A short film about professional lawn care:

This is not rocket science. This is patented professional lawn care. Three minutes and twenty seconds about just another day with the MowFleet system.

How we install the MowFleet system:

This is what’s happening before the robots get to work. It’s also the correct answer to the question ’How do we get grid-independent?’

First, let’s create a carefully evaluated map of all the green spaces the system shall mow. These spaces will be divided into zones. A zone is equal to the robot’s capacity during one work shift (up to 10 hours without charging). If a zone gets mowed once per week, the result will be better. Every new day means that the robots are moved to new zones, hereby utilizing their full capacity.

Time to install the guide cable. The machine will cut a narrow groove about 2 inches deep into the grass. The same machine carries a large roll of cable (look closely, and you’ll see a white reel with a green cable). Looks like marking the lines on a tennis court, right? In every corner, a small staple is secured to the ground. It’s simple, and it works like a charm.

No electricity is needed for the spaces being mowed. To define each zone, a cable is connected to a base plate. A battery-powered base unit is then connected to each zone, sending a low voltage signal through the cable. The base unit is paired with a MowFleet robot, just like any stationary robot would be paired with its charger.

The quintessential MowFleet installation consists of 10-12 robots. A dozen robots have the capacity to mow up to 168 zones if operating in double shifts during a seven-day week. Most users will operate the robots only at daytime on workdays, charging the robots and base units overnight. If needed, the robots are ready to go back to work after only a 90-minute charge, making double shifts an option.

Även den här webbplatsen använder kakor för att bli bättre. Klicka om det är OK.